With two pressure unit "PSI, BAR " and two temperature unit? Please unscrew the sensor to match again or start the car for meters when one of the sensors' values can't be shown up at the first time.
New tire pressure monitoring system with 6 sensors save gas, forsee air leakage, reduce tire wearout, balance tire pressure, ensure safety driving How to set the sensors into correct tire? Turn on your monitor(press the right button for 5 seconds until monitor is on) 2. Press "set" button for 35 seconds(no release) until the monitor enter into parameter mode, and press left button or right button to the page which you can see "on" near the tire or two "--" near the tire.
Press "set" button one time, the tire and "--" flashing, then take out the tire(which number is corresponding to the flashing tire). For example, "1" sensor is corresponding to left front tire. And you should tighten the sensor into the tire, then release, repeat 1 or 2 times, you will see "--" turns into "on", then this sensor is matched to the tire. Repeat step 3 to other sensors until all sensors matched.
After pairing successful, Press "set" button until 35 seconds to exit to standby mode. Note: Please power on the monitor first. Otherwise, The pressure and degree may show up on the monitor after a long time.
Input Voltage:DC5V Transmitting Frequency:433.92MHz Size(LWH)mm:1307570mm Weight:104g. Pressure Range:0-200psi(0-13.7bar) Pressure Precision:±1.5PSI(±0.1bar) Temperature Precision:±3? 1x T650 Monitor 6x Sensors 6x Theftproof nut 1x USB power cord 1x Anti-slip mat 1x Spanner 1x Open cover wrench.
This item is in the category "Vehicle Parts & Accessories\Car Parts & Accessories\Wheels, Tyres & Parts\Tyre Pressure Monitoring Sensors". The seller is "kdscanner" and is located in this country: CN. This item can be shipped to United Kingdom.